Joining Steel Brake Pipes

My profile my preferences my.

Joining steel brake pipes.

Brake lines suffer impact breakage and corrosion over time and need to be replaced. And he said no problem with joining the. There are three main methods of joining pipes together and attaching fittings to them. Flaring steel brake pipes.

I have a corroded steel brake pipe on the car it is only about 50mm at the rear end the rest of the line to the front of the car is sound. Flaremaster joining brake pipes. I have to change the brake pipes on my son s car as they are rusted over the back axle. I have a bit of a prob i need to join two sections of 1 4 brake pipe.

However these pipes can deteriorate to the point where they start to leak causing a dangerous loss of brake fluid and eventually partial or even complete failure of the braking system. It would therefore be easier if it is possible to shorten it flare the end and use a joining piece to new pipe for the remainder of the length. Lines of 2 inch or larger are usually butt welded this being the most economic leak proof method. Smaller lines are usually joined by socket welding or screwing.

Discussion in general land rover forum started by honolulujoe apr 5 2017. Joining two brake lines together with a new spliced section can be accomplished with a few specialty tools and some basic steps. Some say it is not possible with steel only copper.